8/23/2020 0 Comments Devicenet Configurator Software
For Devicenet, we dont have EDS import functionality in the project.However with the project you can compare what is deployed with what your project configuration.
![]() In so doing I found that to configure a DeviceNet device in LV2012SP1, I do not need to manually type in the EDS file data. This addressed questions I had in previous Forum posts: here concering loading EDS files in LabView and here concerning configuration of a DeviceNet network. Basically the slave device was not set to the correct number of InputOutput Bytes in the EDS file, i.e. Find the EDS File for the specific device you wish to replace and delete it ). Which is something I had not been able to previously accomplish. And, in so doing I discovered how the device is talking and why each module did not display. ![]() So I did not look into it further.) Because I was using a standard EDS file, only the one single slave device showed, and thus the data for each module is in the stream of bytes returned over the DeviceNet network. Addressing each module is a matter of parsing the bits and bytes appropriately. Devicenet Configurator Software Update On DeviceNetIs there any update on DeviceNet configuration for non-LabVIEW PCs. I am not sure if this is possible in your case, but you always scan the network using explicit messaging and figure out. Since DeviceNet follows the ODVA specification, I think that all DeviceNet slaves support Class 0x5, Instance 2, Attribute 7 and Attribute 8 which provide this information via explicit message connection and the Get Attribute VI.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |